Page 1 of 1

6" curve sawing gang- kerf questions

PostPosted: Mon Aug 09, 2010 7:54 pm
by Bret
I am new here so forgive me if this ground has already been covered. Currently we run a .90 plate with a.125 kerf, stellite tipped. Our curve saw does not have chip heads. My question is do any of you run thinner kerf? We run 450 feet per minute on high speed. Any reccomenations?

Re: 6" curve sawing gang- kerf questions

PostPosted: Fri Mar 28, 2014 12:55 pm
by Banksblade
How small do you let your tip get before u re-tip?