Page 1 of 1

Armstrong no.4 Bandsaw Grinder

PostPosted: Sat Jul 30, 2016 7:22 pm
by Bberkley1
I'm interested in any information about the Armstrong no.4 bandsaw grinders that any of you may have to share via. Essay, trial and error experience. Including faceplate alignment technique and tools, linear slide mods, replacing/changing/adjusting cams, feed fingers, adjusting hook angle, replacing or adjusting coneskrews etc.etc. please fill me in on your knowledge and experience. I'm interested in all possible responses. Thank you!

Re: Armstrong no.4 Bandsaw Grinder

PostPosted: Sun Jul 31, 2016 1:47 pm
by cowpooie
http://www.armstrongblue.com/publications/publications_frames_page.htm

Go to above web site, click on publications and scroll down to band saw sharpeners......There is enough information here and the additional sites to get you started.....These are Armstrong's recommended way of doing things (not necessarily the fastest or best).....But if you are unfamiliar with the grinder, this is probably the best way to get acquainted.........Good Luck