Page 1 of 1

Software used in the filing room

PostPosted: Sat Nov 14, 2009 12:48 pm
by st1100
Hi there I was wondering if anyone knows where I can buy software to figure out my feed speed for my Bandsaws and well as my Edger Saws.
Thanks
Allan Lessard
Grande Prairie,Alberta

Re: Software used in the filing room

PostPosted: Wed Dec 02, 2009 2:43 pm
by j.nash
Go to TKT web site and they have filers calc,s. Armstrong have one you can down load to.

Re: Software used in the filing room

PostPosted: Sat Dec 05, 2009 3:02 pm
by st1100
thanks for the reply I will do that.

Allan

Re: Software used in the filing room

PostPosted: Fri Feb 26, 2010 2:21 pm
by sawfin
Forintek ask for Bruce Lehmann his # is 1-604-224-3221 cell # 1-604-803-5383