Armstrong no.4 Bandsaw Grinder

Issues related to bandsaws: Benching, tipping, sharpening, feeds and speed, alignment, guides.....

Moderator: thinkerf

Armstrong no.4 Bandsaw Grinder

Postby Bberkley1 » Sat Jul 30, 2016 7:22 pm

I'm interested in any information about the Armstrong no.4 bandsaw grinders that any of you may have to share via. Essay, trial and error experience. Including faceplate alignment technique and tools, linear slide mods, replacing/changing/adjusting cams, feed fingers, adjusting hook angle, replacing or adjusting coneskrews etc.etc. please fill me in on your knowledge and experience. I'm interested in all possible responses. Thank you!
Bberkley1
 
Posts: 1
Joined: Sat Jul 23, 2016 3:11 am

Re: Armstrong no.4 Bandsaw Grinder

Postby cowpooie » Sun Jul 31, 2016 1:47 pm

http://www.armstrongblue.com/publications/publications_frames_page.htm

Go to above web site, click on publications and scroll down to band saw sharpeners......There is enough information here and the additional sites to get you started.....These are Armstrong's recommended way of doing things (not necessarily the fastest or best).....But if you are unfamiliar with the grinder, this is probably the best way to get acquainted.........Good Luck
cowpooie
 
Posts: 2
Joined: Fri Mar 04, 2016 7:24 pm


Return to Bandsaws

Who is online

Users browsing this forum: No registered users and 0 guests

cron